21
MAINTENANCE
Air Filter
• To clean, remove the screws then remove outer casing.
•
• Remove the foam element.
• Wash the foam element in solvent and let dry.
• Pour a small amount of oil on the foam element then squeeze out, but do not
wring out, excess oil. Foam element should be damp, but not dripping.
•
Do not run the generator without reinstalling the foam element or excessive piston and
cylinder wear may result.
CAUTION!
•
• Remove screws, then remove the muffler cover as shown.
• .
•
•
•
•
• Install the outer casing and tighten the screws.
•
• Allow hot components to cool before touching.
WARNING!
Avoid contacting hot areas of this unit.
OIL
To Next Page
Loading...
