9 10
Heat Settings
The Pulsar
®
Vibe has a temperature range of 350°F-430°F. To change
heat setting during use, use temperature buttons to select desired
temperature. Allow the Pulsar Vibe to adjust the temperature, and
then continue vaping.
IMPORTANT Tips: Your Pulsar
®
Vibe is equipped with a 5-minute auto-
shutoff timer to prevent waste and overheating, always allow unit to
cool 5 minutes between cycles whenever possible, but you may turn
the unit back on immediately to finish any herbal blends left in the
chamber. Occasionally stir herbs and allow chamber to reheat for 5
seconds between each inhale.
4. Press function button 5 times to turn on the screen. This unit will
automatically begin heating to the last used temperature.
You can adjust the temperature setting at any time during
use. The range of the Pulsar
®
Vibe is 350°F – to 430°F.
5. Using the arrow keys adjust the temp to the degree of
preference. Pulsar
®
Vibe will remember your last setting
(Factory setting will be 350°F). The screen will show the
word “heat” while the power button flashes. Once the
temperature setting is met the light will stop flashing &
become solid and the screen will read “warm”.
6. Once the desired temperature is reached, you may want
to give the unit another 30 seconds and then take a long,
slow draw and enjoy your vape!
7. To manually shut off your Pulsar
®
Vibe push the On/Off
function button 5 times within 3 seconds; otherwise the unit
will turn off after 5 minutes.
To Next Page
Loading...
Need help?
General
