Pulse Secure PSA7000 - INT;EXT Fiber Port LEDs (PSA7000 F); Fiber Port LED Indicators

© 2017 Pulse Secure, LLC. All rights reserved
9
PSA7000 Hardware Guide
The PSA7000F has four INT/EXT fiber ports located on the front:
Each SFP+ connector has two LEDs. The LED on the left indicates the activity status of the connector.
The LED on the right indicates link speed:
LED
Color
Description
Activity
Blinking green
Activity
Link
Yellow
1 Gbps link speed
Green
10 Gbps link speed
Beeping and Alarms
Beep Code
Description
5 short beeps + 1 long beep every
5 seconds
No memory detected in the system
Continuous beep (“i” LED on
front panel turns RED)
System overheat condition
Continuous beep (Power failure
LED comes on, Front panel)
a) Both power supply modules connected but one power cord
connected
b) One of the two power supplies has failed