To Next PageTo Next Page
Need help?Do you have a question about the Pure Humidifier INTAC and is the answer not in the manual?
General| Brand | Pure Humidifier |
|---|---|
| Model | INTAC |
| Category | Controller |
| Language | English |
Displays operational status and system parameters on the main screen.
Accesses and modifies control settings for the humidifier.
Configures water-related settings and communication parameters.
Adjusts Proportional, Integral, and Derivative control loop parameters.
Configuration options for initial setup and installation parameters.
Details the SCR control method for electric humidifiers.
Describes operation for steam and gas-fired humidifiers.
Limits humidifier output based on supply air humidity in VAV systems.
Protects against freezing and maintains standby water temperature using a thermocouple.
Adjusts output based on ambient temperature to prevent wetting of surfaces.
Procedures for calibrating the outdoor air temperature sensor.
Diagrams illustrating common wiring setups for sensors and terminals.
Explains error codes E01 and E02 related to safety and dedicated inputs.
Details error codes E03 for relative humidity sensor issues (under/over range, calibration).
Covers error codes E04 and E05 for high-limit and outdoor air sensors.
Explains error codes E06 and E07 related to water temperature and level sensing.
Details error codes E07 for water level faults, including float and tri-probe issues.
Covers module errors (DLCM, WLCM) and RH alarm codes (A01).
