Dynamic range control
Dynamic Range Control (DRC) is used to make quieter sounds in a digital radio broadcast easier to hear at
low volume or in a noisy environment. Check with the broadcasters to find out if they use DRC.
To change the DRC settings:
1. Press the Menu button.
2. Turn and press the Select dial or use the <Select> buttons on the remote control to choose
‘DAB Menu’.
3. Turn and press the Select dial or use the <Select> buttons on the remote control to
choose ‘DRC’.
4. Turn and press the Select dial or use the <Select> buttons on the remote control to choose
between one of the following options:
DRC High: Applies maximum compression to the DRC level.
DRC Low: Applies reduced compression to the DRC level.
DRC Off: Removes DRC compression.
Removing inactive digital radio stations from the station list
1. Press the Menu button.
2. Turn and press the Select dial or use the <Select> buttons on the remote control to choose
‘DAB Menu’.
3. Turn and press the Select dial or use the <Select> buttons on the remote control to choose ‘Trim’.
4. Turn and press the Select dial or use the <Select> buttons on the remote control to choose ‘Yes’.
Evoke will remove all inactive stations from the station list.
FM radio settings
Note: You can only see the FM radio settings when you have selected ‘FM’ as the radio source.
FM stereo option
You can choose between the ‘Stereo Allowed’ or ‘Forced Mono’ reception setting when listening to FM
radio. Mono may improve clarity where stereo signals are weak.
To change between Stereo or Mono reception:
1. Press the Menu button.
2. Turn and press the Select dial or use the <Select> buttons on the remote control to choose
‘FM Menu’.
3. Turn and press the Select dial or use the <Select> buttons on the remote control to choose
‘Audio Setting’.
4. Turn and press the Select dial or use the <Select> buttons on the remote control to choose
between ‘Stereo Allowed’ or ‘Forced Mono’ reception.
To Next Page
Loading...
