PURE FlexiPump - INSTALLATION: Set-Up Power Supply

To Next Page

To Previous Page

The FlexiPump system can be inserted into the corner well of the PureStation Sink Insert, or along the side

ridges molded into the sink.

OPERATION

Set-up: on Pure Station™ Sink Insert

The FlexiPump unit is not meant

to be submerged; use caution

when installing near water.

Once your FlexiPump system has been installed in its preferred place, remove the black power cord from

your FlexiPump box. Take the barrel end of the gray cord found at the back of the FlexiPump and insert the

barrel end of the black power supply to the gray cord. Make sure there are no frays in the wires.

Once both barrel cords have been tightly secured, plug the power supply into your wall outlet. Run the

forward ﬂush on your FlexiPump to make sure that the power has been installed correctly.

Set-up: power supply

Do not submerge the power or

barrel cords. Please use caution

when installing near water.