Need help?Do you have a question about the PURE FlexiPump and is the answer not in the manual?
General| Brand | PURE |
|---|---|
| Model | FlexiPump |
| Category | Medical Equipment |
| Language | English |
How to connect the FlexiPump injector tube to the endoscope's suction, air/water, and other channels.
Guidance on capping unused tubes and selecting flush function/speed for endoscope flushing.
Referencing endoscope IFUs for pressure requirements and selecting appropriate tube sets (low/high pressure).
Rules for using one, two, or three tubes with appropriate speed settings (Low, Medium, High) for endoscopes.
Explanation of Forward Flush (time-controlled), Speed/Volume (LEDs), Impact Cycle (clogs), and Stop functions.
Daily procedure for disinfecting tube sets using disinfectant, followed by a clean water rinse.
Step-by-step guide with images for removing the old tube set and installing a new one onto the pump.
Procedure to test FlexiPump's dispensing accuracy at low, medium, and high speeds using water.
Solutions for no power, non-responsive buttons, pump not running, or rotor spinning without fluid.
Resolving leakage, tube set cracks, unit not running with red light, speed control stuck, or noise.
To Next Page