13
Advanced setup
If your wireless network is not broadcasting an
SSID, you will need to configure your wireless
settings manually.
1. Press the Advanced tab to open the Advanced
screen.
2. Enter the SSID of your router and select the
encryption type of your wireless network from
the drop-down list below.
Note: Please check your wireless router
configuration to find out the type of encryption
that is being used on your wireless network.
3. Enter the key/password needed to connect
to your network in the box below, if one is
required.
4. Choose whether to assign a DHCP or Static
IP address to Jongo by clicking the appropriate
radio button. If assigning a static IP address,
enter the IP address settings in their respective
fields.
5. Press Save. Jongo will restart and switch on in
Wi-Fi Connected mode.
You will now be able to stream audio from your
smartphone or tablet (see “Streaming from a
smartphone or tablet” on page 9 for more
information).
Clear network settings
To clear all network settings, press the Clear
network settings button.
Note: You will need to reconnect to Jongo in Wi-Fi
Setup mode to re-configure the network settings.
Troubleshooting
If you are having problems connecting Jongo to
your network, press the Troubleshooting link to
view a series of pages that will guide you through
the Jongo setup steps.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
