6
Switching between Sleep, On and Off
Jongo has three power states, Sleep, On and Off. In Sleep, Jongo remains connected to the wireless
network and waits to receive audio. If the Bluetooth adapter is inserted, Jongo is also ready and waiting to
receive Bluetooth pairing / connection / playback requests in Sleep (Power light is amber).
To enter Sleep, briefly press the Power button (Power light turns amber).
Once in Sleep, press the Power button to switch to On (Power light turns green).
To turn Jongo off, hold the Power button until the Jongo power light turns red, then release.
Note: Before switching off completely, Jongo will check to see if your ChargePAK needs additional time to fully
charge. The Power light will light red while the ChargePAK is charging. When Jongo has finished charging, the
Power light will turn off.
Note: Switching between Sleep, On and Off is different if Jongo is being powered by a ChargePAK. See page
15 for more information.
Power light states
The Power light on Jongo is also used to indicate the various states of Jongo, by colour.
Green
(Pulsing three times) Indicates that Jongo is preparing to stream audio.
(Pulsing continuously) Indicates that Jongo is busy connecting to a
wireless network.
Green/Amber (Alternating) Indicates that you have connected your setup device
(smartphone/tablet) to Jongo Setup Manager in Wi-Fi setup mode.
Red (Pulsing) Indicates that Jongo is booting up.
(Flashing continuously) Indicates that Jongo has an error (e.g. Jongo has
failed to connect to your Wi-Fi network).
Amber (Flashes twice) Indicates that you have tried to increase the volume but
Jongo is already at maximum volume.
(Flashes continuously (slowly)) Indicates that Jongo is in Wi-Fi Setup mode.
(Flashes continuously (rapidly)) Indicates that Jongo is waiting for a file
before carrying out a software update.
Green/Red/Amber (Flashing colour cycle) Indicates that Jongo is carrying out a software update.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
