14
Connecting Jongo to your wireless network using Push Button
Configuration
You can use Push Button Configuration to connect Jongo to your wireless network if WPS is supported by
your router. Refer to your router user guide for more information on WPS.
1. Press the WPS button on your router.
2. Press and hold the WiFi button on the rear of Jongo until Jongo’s Power light pulses green. Jongo will
attempt to connect to your network.
3. When Jongo’s Power light is steady green, Jongo has successfully connected to your network using Push
Button Configuration. You will now be able to start streaming tracks to Jongo. See page 9.
Note: The Power light on Jongo will flash red if Jongo doesn’t establish a Push Button Configuration
connection within 2 minutes.
Note: The WPS function in some WPS-compatible routers may be disabled by default. Consult your router
documentation for more information.
Appendix
Adding another Jongo to your network?
If you have already set up your first Jongo, you can easily add a new Jongo to your network by carrying out
the following steps:
1. Switch on your new Jongo.
2. Press and hold the Wi-Fi button on any Jongo that is already connected to your network until the
Power light pulses green.
3. Press and hold the Wi-Fi button on the back of the new Jongo until the Power light pulses green.
After around 30 seconds, the Power lights on both Jongos will light steady green to confirm that the new
Jongo is connected to your network.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
