When RESET lights flashing, the corresponding pin configuration will output the corresponding level,
This can be used to control the three-axis enable, or machine work tips.
Enter safe altitude baskets
Once entered, saved in the system
G Script Parameters G2/G3 tolerance refers to the input G2/G3 after manual calculations or other calculations. Because of the accuracy problems,
so that circular arc center is inconsistent with the values given moment, there is a tolerance value, the system will be based on the given parameters,
recalculate the best center coordinates, visible G2/G3 detailed instructions.
Chord length: curved Chord length is when generating system to fit an arc segment,See detailed description of G Script
Advanced operating functions:
To Next Page
Loading...
Need help?
General