16
SEVERE SERVICE INSTALLATION
Installing Cables to the Nosebox (Direct Max Only)
Step 1: Remove cover on the side of
the DIRECT MAX.
Step 2: Install 4-gauge cables
as shown. Make sure each
connection is torqued to 5 -lbs.
Replace the side cover.
Note: e mega fuse used here is a
200 amp fuse.
Step 3: Route the 4-gauge red and
black cables behind the front
cover, then under the header plate
through the air/electrical tube to
the center channel.
Important: Avoid sharp edges and possible chang points.
To Next Page
Loading...
