other browser. The default network parameters are shown in the following table:
Table 1. Default network parameters
Open the browser, enter 192.168.1.1 in the URL blank, and press Enter, it will navigate to the following webpage.
After entering the login password, clicking login, the web page will show configuration page of USR-M300.
Figure 1. Login webpage
2.3. Brief introduction of the webpage
There are several tabs on the top of the webpage, users can set parameters of USR-M300 on the tab pages.
➢ Overview：On this page, users can quickly learn about the running status of the gateway, like system
information, device status, cellular information and etc.
➢ Network: In this interface, there are many categories related to network connection. Users can set
parameters such as WAN port, LAN port and cellular network.
➢ Edge Computing: With this functionality, the M300 gateway serves as host and actively sends the
polling acquisition command to periodically obtain the point data of the serial and Ethernet devices
To Next Page
Loading...
General