QuickDraw
Storage and Semi-instantaneous
Boiler Water Heater
2 PV500-26 05/13
TABLE OF CONTENTS
1. Safety Considerations
2. Product Descriptions
3. Water Heater Installation
3.1 Checking Equipment Before You Install
3.2 Codes
3.3 Electrical
3.4 Location
3.5 Installation
3.6 Service Clearances and Clearance to Combustibles
4. General Guidelines
4.1 Water Inlet / Outlet Connections
4.2 Boiler Water Piping
4.3 Relief Valve Piping
4.4 Filling the Unit
5. Operating and Safety Controls
5.1 Operating Temperature Control
5.2 Thermostat Settings – for QuickDraw Semi-Instantaneous Heaters only
5.3 High Water Temperature Limit Control
5.4 Electronic Low Water Cut-Off (optional)
5.5 Sequence of Operation
6. Start-up Procedure
7. Maintenance
7.1 Temperature and Pressure Relief Valve
7.2 Thermostats and Temperature Limiting Device
7.3 Control Valve Actuator
7.4 Tank
7.5 Cleaning the Heat Exchanger
7.6 Checking and Adjusting 3-way Valve Operation
7.7 Recommended Maintenance Schedule
8. Troubleshooting Notes
Warranty forms ship separately with each product.
To Next Page
Loading...
