To set the value of output voltage
for channel, in the tab of the
channel, select the appropriate
value between 0 and 255. In order
to accept the settings, press
"enter". Selecting zero means
setting the minimum value.
NEXT
NEXT
...........
NEXT
NEXT
NEXT
NEXT
ENTERENTER
2x NEXT
ENTER
9.1. Scenes
In dEF menu, select a scene (there are four scenes available to choose from) that you want to
program and press "enter". The display shows CH1 – the first channel. Press "enter" to start
editing the channel.
9.2. Programs
In dEF menu, select a program (there are two programs available to choose from) that you
want to set and press "enter".
To set the value of output
voltage for channel, in the
tab of the channel, select
the appropriate value
between 0 and 255. In
order to accept the
settings, press "enter".
Selecting zero means
setting the minimum
value.
ENTER
4x NEXT
ENTER
ENTER ENTER
NEXT
NEXT
...........
NEXT
NEXT
NEXT
...........
NEXT
NEXT
NEXT
NEXT
NEXT
ENTER
NEXT
2x NEXT
In order to set the playing speed of the program, in the program tab press "enter". Then enter
the program settings step and go to the field Spd. Repress "enter" and select the appropriate
value from 0.1 to 25.0 seconds. In order to accept the settings, press "enter".
In order to change the speed of changing the steps,
press "enter" in the tab of the selected program. Then
click "next" or "previous" to set FAd parameter. Repress
"enter" and enter the selected value between 0
(transition function) to 100 (completely smooth
transition) by using "previous" or "next". Confirm the
settings with "enter".
Go to the End function if
you want to set the edited
step as the last in the
program. Selecting ‘on’
means that this is the last
step of the program and
the first step will be next.
10
To Next Page
Loading...
Need help?
General
