Pyle PDWM3100 - Troubleshooting

www.PyleUSA.com
9
TROUBLESHOOTING
PROBLEM STATUS SOLUTIONS
No sound
or
weak voice
The transmitter
LCD display o
Turn on the transmitter power.
Conrm that the + / - marks on the battery
match with the head joint of the transmitter.
Insert a new battery.
Conrm whether a head of the AC power
adapter is plugged into the power outlet
and whether the other end is inserted into
the DC power supply socket on the rear
panel of the receiver. Check whether the AC
power outlet is normal and conrm whether
the power supply voltage is normal.
Receiver LCD
display o
The display screen
of the receiver
shows that there is
RF signal.
Adjust higher the receiver’s volume control.
Check the cable connection between the
receiver and the amplier or mixer.
The display screen
of the receiver shows
that there is no RF
signal.
The transmitter and
receiver power
indicators light
Elongate vertically the receiver antenna.
Move the receiver away from side of the
metal objects.
Check if there are obstacles between the
transmitter and the receiver.
Move the transmitter closer to the receiver.
Check whether the receiver and transmitter
are used the same frequency.
Distortion
or excess
of burst
noise
The display screen of
the receiver shows
that there is RF signal
Remove the interference source nearby.
(Such as CD player, Computers, Digital device,
Earplugs monitoring system, etc).
Change the receiver and transmitter to
dierent frequency. Replace the transmitter
battery. If you use multiple system, you can
increase the frequency interval between
various systems.
The
transmitter
can’t be
opened.
Press the transmitter
switch and it doesn’t
work or open once &
closes automatically
Replace the transmitter battery.