Pyle PIPCAM5 - Alarm Service Settings; Motion Detect Armed

More Security ,More Convenience
- 41
-
NOTE: Here upload image now means it can upload images freely, no need alarm triggered.
Click Submit after these settings. Then click Test. You will see the following picture.
If it prompts error information as follows.
Figure 9.5
1) Can not connect to the server. Please check FTP Server is correct or not.
2) Network Error. Please try later.
3) Server Error.
4) Incorrect user or password. Please check the username and password is correct or not.
5) Can not access the folder. Please be sure the folder exists and your account is authorized
6) Error in PASV mode. Please be sure the server support PASV mode
7) Error in PORT mode. PASV mode should be selected if the device is behind a NAT
8) Can not upload file. Please be sure your account is authorized
Please check if parameters you filled in are correct or not. The format of image is like 000DC5D008FA (IPCAM)
_0_20101115152525_25.jpg
Please check if your FTP server supports this format of file name
3.20 Alarm Service Settings

Figure 9.6
Enter Alarm Service Settings page to configure Motion Detection function.
3.20.1 Motion Detect Armed
If enable Motion Detect Armed, it will record and make a sound of alarm when there is motion detection
triggered.