More Security ,More Convenience
not see living video but only some undefined characters, it may be the internet speed problems, especially the
camera work on Wi-Fi.
4.1.13 No pictures Problems with ActiveX Controller
If use IE browser to connect the camera for the 1
st
time, maybe there is no image displayed, and there will be a
clue to install the ActiveX. You can do some settings to enable the ActiveX. (Details: For IE Browser)
4.1.14 Problems with network bandwidth
The image frame rate is subjected to the following factors:
1. Network bandwidth
2. PC performance, network environment and display preference setting (brightness, theme, etc)
3. The number of visitors (Too many visitors will slow down the image frame rate)
4. Choice of switch or hub (Use a switch for multiple IP Camera Servers rather than a HUB)
4.1.15 How to register an account from DDNS web
You can enter http://www.dyndns.com/ and register an account, more details please check the Quick
Installation Guide
4.1.16 Why pop-up the prompt” Fail to connect to the device…”?
This prompt only appeared in the case of using multiple cameras.
When you set multiple cameras, the device status light change to yellow , then please make sure the
camera connected and works correctly.
4.2 Default Parameters
Default network Parameters
IP address: dynamic obtain
Subnet mask: dynamic obtain
Gateway: dynamic obtain
DHCP: Disabled
DDNS: factory DDNS and third party DDNS
Username and password
Default administrator username: admin
Default administrator password: No password
To Next Page
Loading...
Need help?
General