Pyle PLMRB29W User Manual

- 14 -
TROUBLESHOOTING
The following chart will help in solving most problems that may occur.
If you still have questions after going through the checklist, please consult your local customer service
representative. Before going through this check list, refer the wiring and operating procedures.
Symptom
Cause
Solution
No power
The car ignition switch
have not turn on.
If the power supply is connected to
the car accessory circuits, but the
engine is not moving, switch the
ignition key to “ACC”.
The fuse has been blown.
Replace a new one.
Disc can not be loaded
or ejected.
Presence of CD disc inside
the player.
Remove the disc from the player,
and insert a new one.
Inserting the disc in reverse
direction.
Insert the CD with the label facing
upward.
The surface of CD is
extremely
dirty or has been scraped.
Clean the disc or try to replace
a new one.
Temperature inside the car
is too high.
Cool off or until the ambient
temperature return to normal.
Condensation
Leave the player off for an hour or
so, and then try again.
No sound
Volume is in minimum.
Adjust volume to a desired level.
The wiring is not properly
connected.
Check wiring connection.
Sound skips
The installation angle is
more than 30°.
Adjust the installation angle less than
30°.
The surface of CD is
extremely dirty or has been
scraped.
Clean the disc or try to replace
a new one.
The operation keys
do not work
1. The built-in micro-
computer is not operating
properly due to noise.
1. Press the RESET button to
restore the program.
2. The front panel has not
properly installed.
2. Fixed the front panel into its place.
No radio reception.
The antenna cable is not
connected.
Insert the antenna cable firmly into
the antenna socket of this radio
player.
In automatic search mode
the radio does not stop at
a transmitting station.
The transmission signals
are too weak.
Select a radio station manually.

Pyle PLMRB29W Specifications

General

Brand	Pyle
Model	PLMRB29W
Category	Car Receiver
Language	English