Pyle PT8000CH - Page 20

This product can expose you to a chemical or group of chemicals, which may include
“Nickel Carbonate” which is known in the state of California to cause cancer, birth defects,
or other reproductive harm. For more info, go to https://www.p65warnings.ca.gov/.
ww w.PyleUSA.com
20
PROBLEM POSSIBLE CAUSES AND SOLUTIONS
No sound is heard on all
channels
Audio cable to the source component is not
connected properly or the cable is bad. Use another
cable that you know is good.
The Input Selection switch is positioned incorrectly.
Refer to installation instructions for proper settings.
Some or all of the internal fuses are blown. Return
the amplier to your dealer for servicing.
Hum or buzzing sound
is heard.
The sound may be caused by a ground loop in the
system. Try to eliminate this by reversing the AC
plugs of other components in the system.
Other causes include faulty cables.
Amplier will not
turn on
The amplier must be plugged into a live outlet.
The power switch on the front panel must be on.
The Power Mode switch may be positioned
incorrectly.