Pyle PT8000CH - Operation

ww w.PyleUSA.com
18
OPERATION
See Diagram 1 for the location of the following:
Power Switch
The switch marked “Power” on the front panel of the amplier will turn o all
amplier circuitry no matter which turn on mode is selected.
Refer to the “Power Mode Selection” section for further information.
Active LED
When lit, the Active LED indicates that the amplier is operating. Refer to the
“Power Mode Selection” section of this manual for further information.
Protection LEDs
When lit the “Protection” LEDs located on the front of the amplier indicate that
either a fault in the wiring, the speaker, or the amplier has caused the channels
associated with the LED to shut down.
Level Adjustment Knobs
The level adjustment knobs on the back panel of the amplier can be used to
adjust the level of each channel. There are many reasons for needing to adjust the
level. You many wish to closely match other levels in the system, or you may wish
to limit the volume level in an area, such as a child’s room.