Name: Pylontech Force-H2
Brand: Pylontech
Rating: 5 (1 reviews)

Questions and Answers:

T
Timothy ChapmanJul 27, 2025
What to do if the status LED is solid orange and battery module LED is orange on Pylontech Battery Pack?
- J
  Jennifer ConradJul 27, 2025
  If the status LED is solid orange and a battery module LED is solid orange, it could be due to: * **Over/under temperature protection:** Check the environment temperature and wait for the BMS to release the protection. * **Over voltage protection:** Verify the DC charge voltage setting or wait for the BMS to release. * **Under voltage protection:** Use the black start function and then charge the system. * **Battery module BMS failure:** Requires further analysis with a debug tool or replacement of the battery module.
V
vincentleeJul 31, 2025
Why Pylontech Battery Pack has no power output and no LED is on?
- J
  Joseph WolfeJul 31, 2025
  If your Pylontech Battery Pack has no power output and no LEDs are on, consider the following: * Ensure you press the start button for at least 5 seconds to turn on, or 10 seconds for a black start. * The button battery in the controller might be missing or faulty, consider changing the controller module. * The battery voltage may be too low, make sure you have at least 2 battery modules. * The base connector might be faulty, ensure the base is connected correctly or replace it.
C
Cameron HerreraAug 5, 2025
What to do if Pylontech Force-H2 Battery Pack status LED slow flashing orange after turned on?
- S
  Scott KennedyAug 5, 2025
  If, after turning on your Pylontech Battery Pack, the status LED is slowly flashing orange while others are off, it could indicate: * A self-checking failure: Ensure there is no DC voltage or set the correct DC voltage before pressing the start button, then follow the correct turn-on procedure. The DC side has a voltage, but the voltage difference with the battery system is higher than 20V. * A BMS internal failure: Use a debug tool for further analysis or replace the controller module.
B
Brandon DuncanAug 9, 2025
How to fix Pylontech Force-H2 Battery Pack when status LED is solid orange and battery module LED is blue?
- J
  Julie MurphyAug 9, 2025
  If the status LED is solid orange and the battery module LED is solid blue on your Pylontech Battery Pack, check the communication cable PIN and wiring to ensure they are correct, as this indicates a communication loss with the inverter.
J
john44Aug 13, 2025
Why is the status LED fast flashing orange on my Pylontech Force-H2 Battery Pack?

Pylontech Force-H2 Specifications

General

Nominal Capacity	3.55 kWh
Battery Type	Lithium Iron Phosphate (LiFePO4)
Communication	CAN, RS485
Certification	CE, UN38.3, IEC62619
Warranty	10 years
Operating Temperature Range	-10°C to 50°C
Storage Temperature Range	-20°C to 60°C
IP Rating	IP20
Cycle Life	>6000 cycles

Related product manuals

Pylontech US2000 PLUS

6 pages

Pylontech Extra 2000

27 pages

Pylontech Force-H2 User Manual

Table of Contents

Questions and Answers:

Pylontech Force-H2 Specifications

Related product manuals