Pylontech Force-H2 User Manual

3/34
Symbol
in label
The certificate label for EMC.
Symbol
in label
The certificate label for Safety by TÜV SÜD.
Symbol
in label
The certificate label for Safety by TÜV Rheinland.
Symbol
in label
The certificate label for Safety by TÜV Rheinland.
Danger: Batteries deliver electric power, resulting in burns or a fire hazard when they are short
circuited, or wrongly installed.
Danger: Lethal voltages are present in the battery terminals and cables. Severe injuries or death
may occur if touch the cables and terminals.
Warning: DO NOT open or deform the battery module, otherwise the product will be out of
warranty scope
Warning: Whenever working on the battery, wear suitable personal protective equipment (PPE)
such as rubber gloves, rubber boots and goggles.
Warning: Force-H2 system working temperature range: 0℃～50℃; Optimum temperature: 18℃～
28℃ . Out of the working temperature range may cause the battery system over / low
temperature alarm or protection which further lead to the cycle life reduction as well as.
It will affect the warranty terms as well.
Warning: For battery installation, the installer shall refer to NFPA70 or similar local installation
standard for operation.
Caution: Improper settings or maintenance can permanently damage the battery.
Caution: Incorrect inverter parameters will lead to a further faulty/damage to battery.

Pylontech Force-H2 Specifications

General

Nominal Capacity	3.55 kWh
Battery Type	Lithium Iron Phosphate (LiFePO4)
Communication	CAN, RS485
Certification	CE, UN38.3, IEC62619
Warranty	10 years
Operating Temperature Range	-10°C to 50°C
Storage Temperature Range	-20°C to 60°C
IP Rating	IP20
Cycle Life	>6000 cycles