Page 28
12 TECHNICAL SPECIFICATION
12.1 Power supply
Mains input
Power input fuse : F1 T250mAH ceramic
Low voltage output : 13.8 V d.c. fused.
800mA maximum available for external devices.
PCB input : 17V a.c.
Fuses
Low voltage output Bell : F1 1 amp quick blow F1AL (Glass)
Low voltage output AUX : F2 1 amp quick blow F1AL (Glass)
Low voltage output 17a.c : F3 2 amp quick blow F2AL (Glass)
Battery charge voltage : 13.7 V d.c.
Rechargeable battery capacity : 12V sealed lead acid, 2.8 to 7 AH.
12.2 Control PCB
Current consumption
(day mode) : 130mA.
(set mode) : 130mA.
(alarm) : 130mA.
Auxiliary DC output supply : Regulated 13.8V d.c. for use with PIR, microwave and shock sensors.
Extension Speaker load : 16 to 32 Ohms.
Bell : 500mA.
Strobe : 500mA.
PGM 1 : 500mA max.
PGM 2 : 100mA max.
Alarm bell time : 2 to 20 minutes (software programmable).
Zone type : Normally closed loops which activate when opened or short circuit.
Zone loop current : 0.76 to 1.03mA.
Zone activation resistance : 2K Ohms (minimum).
Zone loop activation timer : 0.35 seconds.
Exit timer : 2 to 255 seconds.
Entry timer : 2 to 255 seconds.
12.3 Mechanical
Dimensions : 340 x 280 x 101 mm.
Case material : Polymer.
Colour : White.
Weight excluding battery : 2.6Kg.
12.4 Environmental
Operating temperature : 0 to +40
0
C (+32 to +104
0
F).
Storage temperature : -20 to +60
0
C (-4 to +140
0
F).
12.5 Cleaning
DO NOT use strong detergents to clean this control panel. To remove any dirt or grime, wipe with a clean damp cloth
ONLY
To Next Page
Loading...
Need help?
General
