Page 6
CAUTION
HOT
SURFACES
SAFETY
1. The mains electrical installation should be carried out in accordance with National and local regulations
by a technically competent person.
2. Always remove / isolate the mains supply before carrying out servicing of the panel.
3. Connect the unit to a single pole fused spur. If the neutral cannot be identified use a double pole disconnect
version.
4. The equipment should be mounted so that no access can be gained to the electrical cable entry point.
5. Always mount the equipment vertically. This will ensure the correct airflow inside the unit under a full load.
6. On completion of wiring, all cables should be tied together to prevent any possibility of a loose wire
causing a safety hazard.
7. There are no user serviceable parts inside.
- For continued protection against the risk of fire replace only with the same type and rating of fuse.
- 12V (See section 11 - Technical Specifications)
- Designed to comply with EN60950 and IEC950
- Meets required standards
Fuses
Batteries
Electrical Safety Standards
Telecommunications Safety Standards
Labels
Protective Earth:
must
For continuing electrical safety in the event of a failure of the
electrical safety insulation this equipment be earthed.
Functional earth:
To allow the equipment to operate correctly.
Double installation:
Has two layers of electrical insulation and therefore does not require
any protective earthing.
Hot surfaces:
Surfaces, which may cause injury.
2
To Next Page
Loading...
Need help?
General
