44
PREVENTATIVE MAINTENANCE CHECKLIST
Make sure to read, understand and follow the Important Safeguards and Warnings in this Manual.
CHECK
Marker Light
is “ON”
Stow to Deploy
Position
Bump ‘n Go
Downward
Bump ‘n Go
Outward
Bump ‘n Go
Upward
Bump ‘n Go
Docking
Block
Bump ‘n Go
Date: Bus #: Unit #:
Next Due Date: Mechanic: Unit Cycle Count:
6,000 miles 12,000 miles 24,000 miles
48,000 miles 144,000 miles other
Schedule 10,000 Cycle Service Service Date:
NOTE: Schedule service at 9,500 cycles when QUANTUM® beeps twice for 1 minute at start up.
Driver Interface,
Master Switch
LED Light “ON”
Driver Interface,
Occupant Switch
LED Light “ON”
IMAGE WORKING
NOT
WORKING
FIXED COMMENTS
Check Bump ‘n Go by pressing Occupant Interface and
placing an obstacle in front of the Arm’s pathway.
Do NOT use any body parts as an obstacle.
(Arms attempt to finish function 3 times.)
ONE CYCLE
Stowed, Secured, Stowed
Reset Switch
Press Reset Switch to turn the QUANTUM® “OFF” and “ON”.
1
2
When QUANTUM® Arms are Released, #1 is lit and when
they are Secured, #2 is lit.
To Next Page
Loading...
Need help?
General
