What to do if Q'STRAINT Wheelchair QUANTUM® has no power?
If the QUANTUM® has no power, ensure the wire being used is 18 gauge. There MUST be a minimum power of 15 Amps at 11-15 VDC or 10 Amps at 22-28 VDC going to the QUANTUM®. Also, make sure the vehicle’s ignition and parking brake are on.
What to do if Q'STRAINT Wheelchair QUANTUM® is not responding because system restarted too many times?
If the QUANTUM® is not responding because the system restarted too many times, allow the QUANTUM® to cool down for about 1 minute, and then restart it.
What to do if Q'STRAINT Wheelchair QUANTUM® has restarted the same function several times?
If the QUANTUM® has restarted the same function several times but has not completed the function, ensure there is nothing obstructing the QUANTUM®. If there is an obstruction, remove it and resume the function.
What to do if the Q'STRAINT Wheelchair Driver Interface is not working?
If the Driver Interface is not working, ensure the wire being used is 22 gauge and check wire connections at both ends.
Details on the system's engineering, award, and innovative design.
Information on the system's durable construction and high-quality components.
Benefits of the system for passenger independence and operational efficiency.
Shows the system installation on a bus equipped with a tapping plate.
Shows the system installation on a bus not equipped with a tapping plate.
Description of the aisle-side arm and its function in securing the WMD.
Description of the wall-side arm and its function in securing the WMD.
Explanation of the audible alerts indicating system status and events.
Details the steps to enter and operate the system in service mode for installation.
Explains the system's parked position and the initial arm movement.
Describes the arms moving inward to capture the WMD.
Explains system behavior with and without obstructions during movement.
Describes the process of securely locking and releasing the WMD.
Step-by-step instructions for manually releasing the secured WMD.
Description of the Master Switch and Occupant Switch functions.
Information on the occupant control interface and backrest components.
Step for temporarily securing the unit onto the mounting plate.
Steps to remove cover and access the electrical panel.
Connecting the power source wire to the electrical panel connector.
Steps to remove manual release cover and enter service mode.
Arms extend automatically; unit balances to stand upright.
Marking the mounting plate's final location on the floor.
Positioning the plate, marking holes, drilling, and cleaning.
Choosing between 'Option N' (with tapping plate) and 'Option P' (without).
Securing the backrest and connecting various system harnesses.
Routing wires through covers and securing the main unit to the mounting plate.
Permanently installing the backrest and attaching the base feet.
Instructions for installing the floor marker according to specific measurements.
Detailed steps for installing the occupant securement system in US vehicles.
Detailed steps for installing the stanchion support for buses without tapping plates.
General| Brand | Q'STRAINT |
|---|---|
| Model | QUANTUM |
| Category | Automobile Accessories |
| Language | English |
To Next Page
