EasyManua.ls Logo

QDI P5I430TX Titanium IB+ - 3.6 Power Management Setup

QDI P5I430TX Titanium IB+
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AWARD BIOS Description
3 -
10
Timing ... Fast MA to
RAS# Delay
configurations.
• System BIOS
Cacheable
Enabled
Other than conventional memory, the
system BIOS area is also cacheable.
Disabled
The system BIOS area is not cacheable.
• Video BIOS
Cacheable
Enabled
Besides conventional memory, video BIOS
area is also cacheable.
Disabled
Video BIOS area is not cacheable.
• 8 Bit I/ O Recovery
Time
1∼ 8
Defines the ISA Bus 8 bit I/O operating
recovery time.
NA
8 bit I/O recovery time does not exist.
• 16 Bit I / O Recovery
Time
1∼ 4
Defines the ISA Bus 16 bit I/O operating
recovery time.
NA
16 bit I/O recovery time does not exist.
• Memory Hole At
15M-16M
Enabled
Memory Hole at 15-16M is reserved for
expanded PCI card.
Disabled
Do not set this memory hole.
• Pipeline Cache
Timing
Faster
Fastest
This item allows you to select two timings
of pipeline cache, faster and fastest.
• Chipset NA#
Asserted
Enabled
Disabled
This item allows you to select between two
methods of chipset NA# asserted during CPU
with cycles/CPU line fills Enabled or Disabled.
• Mem Drive Str.
(MA/RAS)
10mA/16mA
10mA/10mA
16mA/16mA
16mA/10mA
This item allows you to select the memory
drive strength. If high loading SIMM RAM is
used (the number of memory Chips are more
than 64), you should select 16mA/16mA.
• DRAM Refresh Rate
15.6us
For SDRAM and/or EDO/FPM memory
subsystem.
31.2us
For EDO/FPM only memory subsystem.
64.4us
125us
256us
Disabled
Refresh disabled.
3.6 Power Management Setup
ROM PCI/ISA BIOS (2A59IQ1G)
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
Power Management : Disabled ** Reload Global Timer Events **
PM Control by APM : Yes IRQ [3-7, 9-15], NMI : Enabled
Video Off Method : V/H SYNC + Blank Primary IDE 0 : Disabled
Video Off After : Suspend Primary IDE 1 : Disabled
Modem Use IRQ : NA Secondary IDE 0 : Disabled
Doze Mode : Disabled Secondary IDE 1 : Disabled
Standby Mode : Disabled Floppy Disk : Disabled
Suspend Mode : Disabled Serial Port : Enabled
HDD Power Down : Disabled Parallel Port : Disabled