EasyManuals Logo

QNAP TS-1685-D1521-8G User Manual

QNAP TS-1685-D1521-8G
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
data after the advanced system reset, create the same network share folders on the NAS
and the data will be accessible again.
2.3 USB One Touch Copy
System
Number of seconds (press the one touch copy button
to trigger data copy)
All NAS models 0.5 sec
Data Copy by the Front USB Port
The NAS supports instant data copy backup from the external USB device to the NAS or the
other way round by the front one touch copy button. To use this function, follow the steps
below:
1. Make sure a drive is installed and formatted on the NAS. The default network share
Qusb or Usb is created.
2. Turn on the NAS.
3. Log into QTS as an administrator.
4. Go to “Main Menu” > “Backup Station” > ”USB One Touch Copy”.
5. Under One touch backup for external device, select USB One Touch Copy.
6. Configure the behavior of USB One Touch Copy.
7. Connect the USB storage device to the front USB port of the NAS.
8. Press the Copy button. The USB LED will flash. The data will be copied to or from the
USB device according to the NAS settings.
Note:
This feature adopts incremental backup. After the first time data backup, the NAS only
copies the changed files since the last backup.
This feature is only available on certain NAS models. Please refer to the product
specification table for details at www.qnap.com.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QNAP TS-1685-D1521-8G and is the answer not in the manual?

QNAP TS-1685-D1521-8G Specifications

General IconGeneral
BrandQNAP
ModelTS-1685-D1521-8G
CategoryStorage
LanguageEnglish

Related product manuals