40
System Messages
When an error occurs, a message will appear on the LCD panel. Press “ENTER” to view the
message and press “ENTER” again to go to the next message.
System Message Description
Sys. Fan Failed The system fan fails
Sys. Overheat The system is overheating
HDD Overheat The drive is overheating
CPU Overheat The CPU is overheating
Network Lost Both LAN 1 and LAN 2 are disconnected in failover or
load-balancing mode
LAN1 Lost LAN 1 is disconnected
LAN2 Lost LAN 2 is disconnected
HDD Failure The drive failed
Vol1 Full The volume is full
HDD Ejected The drive is ejected
RX#3 HDD Ejected A drive has been ejected from the expansion unit 3.
M.2 SSD Ejected A M.2 SSD has been ejected and may be defective as
hot-plugging is not supported for M.2 drives.
PCIe SSD Ejected A PCIe SSD has been ejected and may be defective as
hot-plugging is not supported for PCIe devices/
Vol1 Degraded The volume is in degraded mode
Vol1 Unmounted The volume is unmounted
Vol1 Nonactivate The volume is not activated
System Startup
There are several phases in the system startup process:
• System Booting: BIOS and hardware initialization, and system booting (no
actions need to be performed)
• Loading Driver: Loading QTS and its drivers (no actions need to be performed)
• Mount Volume: Prepare volumes (no actions need to be performed)
• Starting Service: Starting NAS system services (no actions need to be
To Next Page
Loading...
Need help?
General
