Setting Up the NAS
Note
Read all safety requirements and information in Safety Information carefully before setting
up the NAS or installing NAS components.
1. Place your NAS device in an environment that meets the requirements.
2. Install the drives.
For details, see the following topics:
• Installing 3.5-inch Hard Drives on 3.5-inch Drive Trays
• Installing 2.5-inch Hard Drives or Solid-State Drives on 3.5-inch Drive Trays
3. Connect the power cord and all applicable cables.
4. Power on the NAS.
5. Install QTS.
For details, see QTS Installation.
6. Log on to QTS.
TS-230 User Guide
Product Overview 10
To Next Page
Loading...
