What to do if I am unable to locate the QNAP TS 28A NAS during QTS installation?
If you are unable to locate the QNAP Storage NAS during QTS installation, it may be because the drives or data are faulty. To resolve this, power off the NAS, remove all the drives, and power it back on. Then, locate the NAS using Qfinder Pro or myQNAPCloud. After locating it, reinsert the drives and continue with the QTS installation.
What to do if Qfinder Pro or myQNAPCloud cannot locate QNAP Storage during QTS installation?
If Qfinder Pro or myQNAPCloud can't find your QNAP Storage during QTS installation, the issue might be with faulty drives or data. To resolve this, power off the NAS, remove all the drives, and then power the NAS back on. Try locating the NAS using Qfinder Pro or myQNAPCloud again. If found, reinsert the drives and proceed with the QTS installation.
General| SSD Cache Acceleration Support | Yes |
|---|---|
| Flash Memory | 4 GB |
| Drive Compatibility | 3.5" SATA HDD, 2.5" SATA HDD/SSD |
| Slot 1 | PCIe Gen3 x16 |
| LED Indicators | HDD, Status, LAN, USB port |
| Buttons | Power, Reset |
| Operating Temperature | 0 - 40 °C (32°F - 104°F) |
| Relative Humidity | 5% to 95% non-condensing |
| Supported RAID Levels | RAID 0, 1, JBOD |
To Next Page
