3. Installation and Configuration
This chapter provides specific hardware and firmware installation and configuration steps.
Hardware Installation
This section provides information on installing drives and replacing memory modules.
Drive Installation
The TS-351 is compatible with 3.5-inch and 2.5-inch hard drives, 2.5-inch solid-state drives, and M.2 solid-
state drives.
Installing 3.5-inch Hard Drives on 3.5-inch Trays
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Power off the NAS.
2. Remove the case cover.
a. Position the NAS on its left side.
b. Remove the screws that secure the case cover to the chassis.
c. Slide the cover to the right to detach it from the chassis.
d. Lift the cover off the NAS.
TS-351 User Guide
Installation and Configuration 11
To Next Page
Loading...
