112
Press “SELECT” to go to the next option and “ENTER” to select an option.
TCP/IP
In TCP/IP, you can see the following options:
1. LAN IP Address
380
2. LAN Subnet Mask
3. LAN Gateway
4. LAN PRI. DNS
5. LAN SEC. DNS
(You can configure the above settings for every interface).
6. Enter Network Settings
a. Network Settings – DHCP
i. Set up DHCP on LAN1 and LAN2.
b. Network Settings – Static IP*
i. Press “SELECT” to switch to the next available option.
ii. Press “ENTER” to configure the selected option. The first digit will begin to
blink.
iii. Press “SELECT” to increment the selected digit, press “ENTER” to confirm the
value, and go to the next digit until all digits are set.
iv. Repeat this procedure this for every setting you want to change.
c. Network Settings – BACK
7. Back to Main Menu
* In this section, you can only configure IP address, subnet mask, gateway, and
DNS of LAN1 and LAN2.
Physical disk
In Physical disk, you can see the following options:
1. Disk Info
To Next Page
Loading...
Need help?
General
Weight and Dimensions
