EasyManuals Logo
Home>QNAP>Network Storage Server>TS-453mini

QNAP TS-453mini User Manual

QNAP TS-453mini
135 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
71
recognized by the operating system, log into QTS as administrator and go to
“Control Panel” > “System Settings” > “System Status” > “Network Status” and
check for total number of network interfaces.
6.3 TVS-473, TVS-673, TVS-873
Note:
1. TVS-473 uses low-profile PCIe bracket.
3. TVS-673 and TVS-873 use full height PCIe bracket.
1. Turn off the NAS. Disconnect power cord(s), network cable(s), and any other cables
attached to the device.
2. Before opening the NAS, wear an antistatic wrist strap and connect the crocodile
clamp to ground to prevent electrostatic discharge from damaging equipment.
3. Loosen and remove the screws on the back of the NAS that are connecting the case
cover to the case.
4. Gently remove case cover from case.

Table of Contents

Other manuals for QNAP TS-453mini

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QNAP TS-453mini and is the answer not in the manual?

QNAP TS-453mini Specifications

General IconGeneral
RAID levels0, 1, 5, 6, 10, JBOD
RAID supportYes
Storage drive size2.5/3.5 \
Storage drive capacity0 GB
Storage drive interfaceSerial ATA III
Storage drives installedNo
Installed storage drive type-
Supported storage drive typesHDD & SSD
Total installed storage capacity0 TB
Maximum supported storage capacity- TB
Number of storage drives installed0
Number of storage drives supported4
Processor familyIntel® Celeron®
Processor frequency2 GHz
Flash memory512 MB
Memory slots2
Internal memory2 GB
Internal memory typeDDR3L
Maximum RAM supported8 GB
Ethernet LAN data rates10, 100, 1000 Mbit/s
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity3
Cooling typeActive
Product colorBlack
Number of fans1 fan(s)
TypeNAS
Operating system version4.1.2
Operating system installedQNAP Turbo System
AC input voltage100-240 V
Power supply locationBuilt-in
Power consumption (sleep)1.04 W
Power consumption (typical)30.23 W
Power supply unit (PSU) capacity90 W
Operating temperature (T-T)0 - 35 °C
Operating relative humidity (H-H)5 - 95 %
Cables includedAC, LAN (RJ-45)
Weight and Dimensions IconWeight and Dimensions
Depth200 mm
Width151 mm
Height210 mm
Weight2000 g
Package weight3400 g

Related product manuals