QNAP TS-464U-RP User Manual

2. Power on the expansion units.
3. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Connecting SATA JBOD Expansion Units
To connect the TS-x64U to SATA JBOD expansion units, a host bus adapter must be installed on the NAS.
For required accessories details, see Expansion Unit Installation.
1. Power o the NAS.
2. Install a host bus adapter on the PCIe slot.
For details, see Installing Expansion Cards on the TS-464U and TS-464U-RP and Installing Expansion
Cards on the TS-1264U-RP.
Important
The QNAP QXP host bus adapter is required for connecting the SATA JBOD enclosure to a host
device. Third-party host bus adapters are not compatible with QNAP JBOD enclosures.
3. Connect the expansion units to the NAS using the following topology.
Note
This image shows connecting the TS-1264U-RP-4G to the TL-R400S JBOD enclosure.
TS-x64U User Guide
Installation and Conguration 36

QNAP TS-464U-RP Specifications

General

Brand	QNAP
Model	TS-464U-RP
Category	Storage
Language	English