116
- Loading Driver: Loading QTS and its drivers(no actions need to be performed)
- Mount Volume: Prepare volumes(no actions need to be performed)
- Starting Service: Starting NAS system services (no actions need to be performed).
Note that applications start only after the system finishes booting.
For TVS-x82 Series, the LCD panel displays additional booting information after you power
on the NAS:
- BIOS xxxxx – xxxx is the BIOS version, which can be used for technical support to
help identify and resolve issues.
- - Startup phases:
o Checking Memory – The system checks the installed memory.
o Powering up all disks – Power up all disks sequentially.
o Hardware initialization – Initialize additional hardware components, such as PCIe
SSD, Graphic card, Thunderbolt adapter, etc.
o Booting - Boot from the DOM. If the startup stops at this step, the DOM may be
defective. Please seek technical support.
o Starting System – Starting QTS. If the startup stops at this step, the QTS
installation may have encountered problems. Please seek technical support.
- The remaining startup phases are the same as those of other NAS models
LCD Panel – QTS 4.2.x and below
Refer to QTS 4.2.x User Manual for details.
To Next Page
Loading...
Need help?
General
