108
7. Gently lower the memory module towards the motherboard until it sits on the riser
screw. While holding down the M.2 SSD in position, insert mounting screw into the
riser screw, tightening as necessary to securely fasten the M.2 SSD in place. Do not
over tighten the screw.
8. Close the case cover and fasten the screws. Connect the power adaptor and cables
to the NAS. Power on NAS.
9. To verify that the M.2 SSD has been installed correctly and is being recognized by
the operating system, log into QTS as administrator. Go to “Main Menu” > “Storage
Manager”> “Disks/VJBOD”. In the “NAS Host” section, check the status of the M.2
SSD.
To Next Page
Loading...
Need help?
General
