QNAP TVS-73e Series - Installing M.2 Solid State Drives

5. Power on the NAS.
Installing M.2 Solid State Drives
Warning
•
Only qualified personnel should perform the following steps. Failure to follow
instructions can result in serious injury or
•
Observe electrostatic discharge (ESD) procedures to avoid damage to
Note
QNAP recommends installing heatsinks onto the M.2 SSD controllers to enhance cooling
efficiency and to ensure consistent performance.
1. Power off the NAS.
2.
Disconnect the power cord from the electrical
3.
Disconnect all cables and external
4. Remove the case cover.
a.
Remove the screws that secure the cover to the
b. Slide the cover back.
c.
Pull the cover up until it completely detaches f
Installation and Configuration
Installing M.2 Solid State Drives
Only qualified personnel should perform the following steps. Failure to follow
instructions can result in serious injury or
death.
Observe electrostatic discharge (ESD) procedures to avoid damage to
QNAP recommends installing heatsinks onto the M.2 SSD controllers to enhance cooling
efficiency and to ensure consistent performance.
Disconnect the power cord from the electrical
outlet.
Disconnect all cables and external
attachments.
Remove the screws that secure the cover to the
chassis.
Pull the cover up until it completely detaches f
rom the chassis.
TVS-x73e User Guide
Installation and Configuration
19
Only qualified personnel should perform the following steps. Failure to follow
Observe electrostatic discharge (ESD) procedures to avoid damage to
components.
QNAP recommends installing heatsinks onto the M.2 SSD controllers to enhance cooling