4. Installation
▒
4-2. Step-by-Step Installation Guide
▒
Attach the device behind or near the rear view mirror not blocking the
driver's vision. Do the same for the rear cam.
※ Detaching and reattaching the adhesive tape causes the tape to
lose its stickiness.
2
User's Guide ... 13
▒
4-1. Before Installation
▒
※ Before installation, please park the vehicle on a level surface and bright area. Turn off the engine and remove the key. (Be sure parking break is ON)
※ Pick a spot for the device behind or near the rear view mirror not blocking the driver’s vision.
※ Do not install the device with the lens facing upwards. Some functions may not work properly. (Weak GPS signal, continuous event recording)
※ Keep the lens clean for optimal video quality.
※ Make sure the device does not interfere with the driver's vision.
※ Adjust the angle of the camera lens, so that is shows approximately 40% of the car bonnet on the bottom of footage.
- If the lens is installed excessively facing downwards, traffic signs may be indistinct. If the lens is facing too high, footage may look dark overall due
to the bright sky.
※ Before concealing the cables, make sure that the F/R connection cable, rear camera and hardwire power cable are all working properly.
Make sure GPS signal is acquired and stable. After testing the above, conceal the cables neatly along the headliner.
※ The manufacturer is not responsible for any damages due to not following above mentioned instructions.
Apply double-sided adhesive tape on the fixed-type mount.
Slide the device into the mount.
※ Check if a microSD card is inserted. The device does not
start recording without a microSD card.
※ Make sure Wi-Fi dongle is inserted into the front cam.
1
①
②
To Next Page
Loading...
Need help?
General