Qrotech OPA-101 - Installing Method; 5-1 Installing Method.

OPA-102/101
OPERATION MANUAL
- 11 -
SECTION 5. INSTALLING METHOD
5-1 Installing Method.
Connect all of cables to the correct port each other on the side of measurement unit.
And connect the probe hose on the rear of the measurement unit. Move the ON/OFF
switch to “ON” position. Then OPA-102 will be start.
◈ Handheld terminal
The handheld terminal is operated together with the display of the measurement
at the same time. (Power ON/OFF: Press the ON/OFF switch for 3 seconds.)