OPA-102/101
OPERATION MANUAL
- 5 -
SECTION 1. QUALITY GUARANTEE REGULATION
If the product is handled according to this manual but there occurs a failure with in the
guaranteed period, it will be repaired free of charge by our company. However, the
compensation from the secondary damage and the following cases may not be guaranteed
and repaired without fee:
(1) Out-of order or damage on the product due to user’s fault, careless
maintenance and inspection, and unsafe keeping.
(2) Out-of order or damage on the product due to the change or reconstruction of
the product.
(3) Any naturally expendable parts such as rubber parts, and required exchange of
those parts which are damaged.
(4) Out-of order or damage due to the use of not designated genuine parts.
(5) Un-clarified items (example: no specifically given item number )
SECTION 2. SAFETY GUIDELINE
Installing place and Precautions
① This product is geared to use AC110V or AC220V only. Make sure the source of
electricity.
② As probe is heated hot, be careful not to be burned when detaching.
③ While analyzing, do not stay long time where sooty smoke emits.
④ While measuring, refrain from moving the product, and install the product at no vibrating
place.
⑤ For the safety purpose, put resistant stuff in front and rear of the tire.
⑥ Install probe and when measurement completed remove it immediately from exhausting
pipe.
⑦ Do not disassemble and reassemble the product on user’s discretion.
To Next Page
Loading...
Need help?
General
