Qrotech OPA-101 - Table of Contents

OPA-102/101
OPERATION MANUAL
- 4 -
< Table of Contents >
Section 1. QUALITY GUARANTEE REGULATION --------------------------------------- 5
Section 2. SAFETY GUIDELINE --------------------------------------- 5
Section 3. INTRODUCTION OF THE PRODUCT
3-1. Introduction ------------------------------------- 6
3-2. Outlook of the appearance
3-2-1. Front / Rear view --------------------------------- 6
3-2-2. Side view ------------------------------------- 6
3-3. Specification ----------------------------------------- 7
3-4. Composition
3-4-1. Measurement unit ---------------------------------------- 8
3-4-2. Basic accessory ---------------------------------------- 8
3-4-3. Option ---------------------------------------- 8
3-5. Display and Outlook of Function Key -------------------------- 9
Section 4. MECHANICAL CIRCUIT
4-1. Principle of Measurement ------------------------------------- 10
Section 5. INSTALLING METHOD
5-1. Installing Method ------------------------------------------- 11
Section 6. INITIAL DISPLAY
6-1. Warming up ------------------------------------------------ 12
Section 7. MEASUREMENT
7-1. Display --------------------------------------------- 14
7-2. Free acceleration test (Normal mode) ---------------------------------------------- 15
7-3. Free acceleration test (Inspection mode) ---------------------------------------------- 16
7-4. RPM Measurement (option) ------------------------------------------------- 19
Section 8. SET-UP
8-1. Calibration -------------------------------------------------- 20
8-2. Time set-up ------------------------------------------------- 20
8-3. Hold set-up --------------------------------------------------- 21
8-4. Printing density set-up -------------------------------------------------- 22
8-5. Cylinder set-up -------------------------------------------------- 22
Section 9. MAINTENANCE AND MANAGEMENT
9-1. Lens Cleaning ----------------------------------------- 23
9-2. Error codes ----------------------------------------- 23