Qrotech OPA-101 - Page 13

OPA-102/101
OPERATION MANUAL
- 13 -
ü CAUTION ü
During above procedures, keep the end of the probe at fresh air available place.
If not placed at fresh and clean air, while adjusting 0-point it shows “Error”
message. When this message appears, check if the end of the probe is placed at
clean air available place or not.
Power On
Initial Process
(10 seconds)
Warming Up
(about 6minutes)
Zero Calibration(10seconds)
Measurement
Ready State
Automatic Processing
Span Calibration
(10 seconds)