Screw in the other four black screws in the
corners of the right-hand side panel.
Apply the supplied four self-adhesive feet to
suitable positions on the base of the
enclosure if desired (optional).
Install the supplied knobs by tightening their
grub screws. Leave a small gap between
each knob and the front panel, to allow the
knob to turn easily. The grub screw of the
volume control knob should be at the
position of the flat on the shaft. The grub
screw position on the rotary encoder is not
important.
Plug in the power…
SUCCESS!
(hopefully)
Disassembly of the QCX-mini should follow similar steps, in reverse.
80
To Next Page
Loading...
Need help?
General
