QSC CX1102 - User Manual

CX Series
User Guide
2-Channel Low-impedance Models:
CX302
CX502
CX702
CX902
CX1102
4-Channel Low-impedance Models:
CX254
CX404
70 Volt Direct Output Models:
CX204V (4-channel)
CX302V (2-channel)
CX602V (2-channel, 8 ohm)
CX1202V (2-channel, 4 and 8 ohm)
TD-000077-00-K
*TD-000077-00*

Summary

EXPLANATION OF SYMBOLS

IMPORTANT SAFETY INSTRUCTIONS

Essential safety guidelines for operating the QSC CX Series amplifier.

Maintenance and Repair

Front Panel

Rear Panel

AC Mains Connection

Setting the Mode Switches

Setting Clip Limiters

Details enabling/disabling the clip limiter function for each channel.

Selecting Stereo, Parallel, or Bridge Mode

Guides on setting the amplifier for Stereo, Parallel Input, or Bridge Mono operation.

Setting Low Frequency Filters

DataPort

Inputs

Outputs

Low Impedance Outputs

Distributed Outputs (“V” models, 70 V;140 V)

LED Indicators

Gain Controls

Specifications

4-Channel Low-Impedance Models

2-Channel Low-Impedance Models

2- and 4-Channel Distributed 70 V Line Models

QSC CX1102 Specifications

General

Channels	2
Power Output (8 Ohms per channel)	1100 W
Signal-to-Noise Ratio	> 100 dB
Input Sensitivity	1.4 V
Damping Factor	> 200
Cooling	Variable speed fan
Frequency Response	20 Hz - 20 kHz
Input Impedance	20 kOhms balanced
Height	3.5" (88.9mm)
Power Requirements	100-240 VAC, 50/60 Hz
Dimensions (H x W x D)	3.5" x 19" x 15.5" (88.9mm x 482.6mm x 393.7mm)