To Next PageTo Next Page
Need help?Do you have a question about the QSC CX404 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Power Output (8 Ohms per channel) | 100 W |
| Damping Factor | > 500 |
| Signal-to-Noise Ratio | > 100 dB |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 20 kOhms |
| Dimensions (H x W x D) | 3.5" x 19" |
| Power Requirements | 50/60Hz |
Key safety warnings and guidelines for operating the equipment safely.
Instructions for removing the amplifier and accessories from its packaging.
How to enable/disable channel clip limiters for distortion protection.
Options for stereo, parallel input, and bridge mono configurations.
Configuring the 12dB/octave low-frequency filters for different impedance models.
Advice on using the DataPort for amplifier control, monitoring, and signal processing.
Instructions for connecting signals via terminal blocks and XLR connectors.
Table showing compatible load impedances and voltage ratings for each amplifier model.
How to install a cover to prevent unauthorized changes to gain settings.
Technical specifications for the CX254 and CX404 4-channel amplifiers.
Technical specifications for the CX302, CX502, CX702, CX902, and CX1102 2-channel amplifiers.
Technical specifications for the 70V distributed output CX204V, CX302V, CX602V, and CX1202V models.
