Need help?Do you have a question about the QSC DCP 100 and is the answer not in the manual?
General| Power Supply | 100-240 VAC, 50/60 Hz |
|---|---|
| Delay | Up to 1000 ms |
| Input Channels | 8 |
| Output Channels | 8 |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion | < 0.01% |
| Signal to Noise Ratio | > 100 dB |
| Maximum Input Level | +24 dBu |
| Maximum Output Level | +24 dBu |
| Audio Outputs | 8 |
| Processing | DSP |
| Control | Ethernet |
| Type | Digital Processor |
| EQ | Parametric |
| Input Impedance | 10k ohms |
| Output Impedance | 100 ohms |
| Channels | 8 |
Covers electrical safety, lithium battery warnings, and symbol explanations.
Details QSC's limited warranty, disclaimers, and terms for DCP products.
Describes the DCP's role in D-Cinema audio systems and its integration capabilities.
Lists general features, including digital inputs, crossovers, and software integration.
Explains the DCP's advanced DSP capabilities for speaker optimization.
Explains the functions of the touch control LCD, Monitor Volume knob, and Mute button.
Introduces the DCP Manager software and the initial system setup process.
Steps for unpacking the unit, installing DCP Manager, and initial DCP configuration.
Instructions on connecting DCP DataPort outputs to QSC amplifiers.
Details on connecting audio sources and external automation devices.
Steps for completing the installation, including SD card insertion and system tuning.
Using DCP Manager via USB for device configuration and management.
Connecting DCP units to a network using QSControl.net and Venue Manager.
Guide to unpacking, identifying carton contents, and rack mounting procedures.
Lists PC requirements and detailed steps for installing DCP Manager software.
Warning about USB driver installation and configuring the DCP via software.
Summary of AC power, QSControl, and CobraNet network connection requirements.
Details on HI/VI outputs, automation inputs, logic, monitor, and relay outputs.
Description of DataPort connections and ancillary analog/digital inputs.
Pinout details for Main and Auxiliary Analog Input connectors.
Pinout details for AES3 Digital Input connectors.
Technical specifications for audio inputs, A/D conversion, and dynamic range.
Specifications for DSP features including crossover filters and parametric EQs.
Details on subsonic, CD Horn EQ, screen EQ, all-pass filters, and delay settings.
Specifications for automation inputs, logic outputs, display, and network protocols.
Describes the RS-232 serial automation protocol and required communication settings.
Explains command syntax and provides a reference for supported serial commands.
To Next Page
