EasyManuals Logo

QSC K8 Service Manual

QSC K8
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
TD-000487-00
K Series Service Manual
3.2 Firmware programming instructions
Warning
If the instructions are not followed carefully, there is a possibility that the amplifier inside the loudspeaker will stop work-
ing. Because House of K loudspeakers use DSP technology, all audio signals are routed through the DSP controller. If the
firmware is not programmed into the DSP controller correctly, then the amplifier will fail to pass audio. While performing a
firmware update, never plug the ribbon cable into the programming header with the amplifier turned on.
Equipment needed
• Total Phase Aardvark I2C Host Adapter, TP240141
• Ribbon cable adapter, 6 pin to 10 pin (not needed for some older K models)
• USB cable, A-type to B-type (included with Aardvark)
• Computer with Windows XP, Vista, or 7 operating system (32 bit or 64 bit okay)
Software needed
• Total Phase USB driver setup file: TotalPhaseUSB-v2.10.exe
• K Programmer Utility (32 bit or 64 bit)
• HEX file which contains specific loudspeaker firmware
Installing the Total Phase Aardvark USB Drivers
This step must be performed before any programming takes place. The installation file for
the USB drivers will work on Windows XP, Vista, 7 (32 bit and 64 bit), and 8.
1. Disconnect the Aardvark if you’ve already connected it.
2. Open the installer file named TotalPhaseUSB-v2.10.exe.
Important Note: There is a known bug in the installer that affects Windows Vista
only. You must run the installer in a different mode. Right-click on the install file Total-
PhaseUSB-v2.10.exe and click on Properties. Click the Compatibility tab and mark the
box titled “Run Compatibility mode for Windows XP (Service Pack 3)”. Click OK to save the
changes.
3. Mark the box titled “Install USB Drivers” and continue with the installation utility until
complete.
4. Connect the Aardvark to the computer with the USB cable.
5. The Total Phase USB drivers will install automatically. You may skip any
Windows Update notification as you do not want Windows to look for USB
drivers via the Internet. Windows will let you know that the drivers installed
correctly with a pop-up window.
Note: If you want to check that the USB drivers installed correctly, go to the
Device Manager under the Control Panel menu and look for “Total Phase
Aardvark I2C/SPI Host Adapter” under Universal Serial Bus controllers.

Other manuals for QSC K8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QSC K8 and is the answer not in the manual?

QSC K8 Specifications

General IconGeneral
Product colorBlack
LED indicatorsPower, Signal strength, Stand-by
Housing materialSteel
Recommended usageDJ
Suitable for outdoor use-
WooferYes
Speaker type2-way
Number of drivers1
Speaker placementFloor
Audio output channels1.0 channels
Woofer diameter (imperial)8 \
Subwoofer driver diameter (imperial)1.75 \
Impedance40 Ω
Sensitivity127 dB
Frequency range61 - 20000 Hz
RMS rated power1000 W
Peak Music Power Output (PMPO)2000 W
Connectivity technologyWired
AC input voltage100 - 240 V
Power source typeAC
AC input frequency50 - 60 Hz
Weight and Dimensions IconWeight and Dimensions
Depth269 mm
Width280 mm
Height450 mm
Weight12200 g

Related product manuals