QSC KC12 - KC12 Deployment; Assembly

12
KC12 Deployment
The KC12 is equipped with custom, high-durability and glass-fiber reinforced quick connectors that allow users to rapidly and safely
deploy their system without any tools or external hardware needed. The top box loudspeaker (KC12T) and subwoofer (KC12S) can
be deployed with or without the column pole (KC-SP32), depending on the application-specific coverage requirements. The KC12S
subwoofer can also be used as a stand-alone subwoofer by utilizing “Sub Only” mode in the menu. (See "Menu Listing" on page 18
for more information.)
CAUTION!: The KC12 should not be used in any kind of flown or horizontal configuration. Potential damage to the unit,
or personal injury may occur.
Assembly
1. Before placing the subwoofer (KC12S), ensure that the surface is level and
structurally sound. The grille of the subwoofer will be in the same direction as the
top box (KC12T once deployed), so deploy the sub with the grille pointed towards
your audience area.
2. (Optional) Insert the coupler located on the bottom of the KC-SP32 into the top of
the coupler receiver on the top of the KC12S (keeping hands, fingers or any other
items clear of the coupler receiver), and press down firmly.
3. Insert the coupler located on the bottom of the KC12T top box loudspeaker into
the coupler receiver on the top of the KC-SP32 or KC12S (depending on your
deployment), and press down firmly.
4. Connect your AC and audio cables to the rear panel.
NOTE: The KC12 is intended for use with a maximum total system of
one KC12T top box, one KC-SP32 column system pole, and one KC12S
subwoofer in a single configuration.
WARNING!: Keep hands, fingers, and any other items clear of the
KC12 couplers and receivers when assembling the system, as personal
injury may occur.
WARNING!: Do not move your system when fully assembled. If you
need to move your KC12, please disassemble the KC12T top box
loudspeaker and KC-SP32 column pole and move the system, then repeat
assembly instructions.
WARNING!: Be careful to not get dust or water into the coupler
sections of the KC12, as this can create potential connection issues for the
system.
KC12T
KC-SP32
KC12S
—Figure4—